Магазин 12х76 барабанного типа псевдо 20 мест для Сайги 12к с ограничителем на 7 патронов Maxrounds PowerMag

The POWERMAG is a very sophisticated mechanism made from the best quality materials.

Preload adjustment for good functionality of the POWERMAG magazine:

• Place POWERMAG on a flat surface,
• Hold fake round nearby feed-lips,
• Strip the screw, see picture 1,
• Using the enclosed no. 4 allen key, turn the spring clockwise, see pict. 2
• Optimum spring settings is between 2-3 turns(depends on used ammunition)
• Using the enclosed no. 3 allen key, tighten the safety bolt on the center axis, see pict. 3

Following the practical check of the functionality of the tightening of the safety bolt of the spring on the center axis. 

Our suggestion:

1. We recommend the usage of ammunition from 32g and higher, failure of your weapon could occur with lighter ammunition.
2. Set the spring to 2.5 turns
3. Set the gas off-take (SAIGA 12) to degree no. 1 For most weapons with calibrations over 1000, these munitions work very well at this setting

Charging the POWERMAG  is very easy by following the recommended method:

• Place the POWERMAG at waist level and slowly spin the sprockets with the fingers of your left hand
• With your right hand, insert the bullets into the POWERMAG.

Repeat this method until you have reached the required capacity of bullets (max. 20)

Mounting the belt clip:

- mount the belt clip onto the POWERMAG is possible, using the two enclosed bolts.

MOST COMMON PROBLEMS

Spring is too tight or not tight enough:

-          For a well-seasoned weapon, a 2 turn setting is usually adequate (1 turn = 360°). Unnecessarily setting the spring too tight will cause excessive resistance of the cap and will lead to failure.     

-          On the contrary, new weapons must be tightened more, usually 2.5 – 3 turns (1 turn = 360°) due to the weapon being un-seasoned.

The cap of the weapon cycles too fast:

-          In some cases, even with the optimum spring setting of the POWERMAG there are holdbacks, the reason could be an improper settings of the gas off-take (SAIGA 12)

-          In most cases, with well-seasoned weapons, setting to degree no. 1 on the gas off-take is sufficient

-          For new or less-seasoned weapons, degree no. 2 is the common setting

It is not possible to insert POWERMAG in the weapon:

-          If it is not possible to insert the POWERMAG into your weapon, it is caused by an excessive tolerance in the make of your weapon.

Solution: amend POWERMAG to fit your type of weapon

-          Send POWERMAG back and we will return the full price, even though the problem was not caused by our magazine.

POWERMAG falls out of the weapon:

-          If the POWERMAG falls out of the weapon, it is caused by an excessive tolerance in the make of your weapon.

Solution: amend POWERMAG to fit your type of weapon

-          Send POWERMAG back and we will return the full price, even though the problem was not caused by our magazine.

While practicing the recharging of the magazine, do not release the bolt over the empty PowerMag unless absolutely necessary – it cause unnecessary wear on the head of the magazine. If you have any problem with PowerMag settings or Saiga or Molot feel free and contact us on telephone +420-608-371-107 or mail info@maxrounds.com.

CONVERSION FOR MOLOT VEPR 12:

Completing the POWERMAG with conversion:

Hold fake round, release spring, push fake round between desks of Powermag, change feed ramps, set up spring – tighten 2.5 – 3 turns  (number of turns depends on used ammunition).

Warning: DO NOT lose the ring of false round at the changing.